41
Similarly, the cutting depth can be set by direct entry or the set cutting depth button.
We will talk about cutting depth again later.
Cutting Check list:
Draw the file. Inside cuts on any layer NOT named outside. All outside cuts
must be on the layer that starts with “outside”. Save the file to dxf. If your CAD
does not close the DXF file when saving, it must be explicitly closed. QCAD will
properly close the file on saving.
Open the File in AvCAM.
Select the layer(s) you want to cut in this operation.
Set the operating mode, I.E. auto tool path
Set the end mill diameter in the cut dialog
Simulate the file
Install the tool on the router
Set the x/y zero. This only needs to be done once for the file.
Set the Z zero, verify retract level and cut depth. The retract may remain the
same for all tools, however the Z zero and cut depth will likely change for each
tool.
Verify router switch is on and the spindle switch on the controller is on.
Verify cut speeds. The cut speed should be in the 20 IPM range for a 1/8” end
mill and 1/8” 2024T3.
Verify adequate coolant in tank and pump plugged in.
Repeat Z zero, cut depth and end mill diameter settings for each tool change.