Bull NovaScale R460 E1, User Manual, Page: 36 / 370

User Guide
35
www.bull.com
Selecting Server Site
To use the server, install it on a standard EIA 19-inch rack assembly.
Refer to the documentation attached to the rack or contact your sales agent for the
installation of the server on the rack.
Warning
Observe the following instructions to use the server safely. Failure to
follow these instructions may result in death or serious personal injury.
See
“General Safety Information” on page 135
for details.
■
Do not use the server in any unapproved place.
■
Do not connect the ground line to a gas pipe.
Caution
Observe the following instructions to use the server safely. Failure to
follow these instructions may cause a fire, personal injury, or property
damage. See
“General Safety Information” on page 135
for
details.
■
Do not carry or install the server only by a single person.
■
Do not install the server where the load may be concen-
trated on a specific point.
■
Do not install any component on the server only by a single
person.
■
Do not pull out a device from the rack if the rack is unstable.
■
Do not leave more than one device being pulled out from the
rack.
■
Do not provide the wiring exceeding the rating power.
Do not install the rack in the places listed below. Installing the rack or mounting the
server on the rack in such a place may cause some malfunction to occur.
■
Narrow space from which devices cannot be pulled out from the rack completely
Making backup copies of system information
After all the system setup procedures are completed, make backup copies of system information.
System information is required for recovering the server from the trouble or after replacing the system
board.