Bull NovaScale R460 E1, User Manual, Page: 147 / 370

User Guide
146
www.bull.com
Installation
Take the following steps to install the CPU.
1. See the section “Preparing Your System for Upgrade” on page 137 to prepare.
2. Pull out the server from the rack.
3. Remove the logic cover and drive cover. See “Logic Cover” on page 143 and
“Drive Cover” on page 141 .
4. Remove the PCI riser module. See “Installing and Removing a PCI Board” on
page 166 .
5. Remove two screws securing the support arm.
6. Remove the support arm from the chassis.
Figure 93: Removing the Support Arm
Note: Loosen the screws when the support arm comes up.
Press firmly the support arm before removing the screws.
7. Remove the processor duct from the chassis.
Figure 94: Removing the Processor Air Duct