Bull NovaScale 3005 Series, Installation And User Manual, Page: 84 / 158

B-6 Bull NovaScale 3005 Series - Installation and User's Guide
B.2.3 Installing the Chassis in the Rack Cabinet
CAUTION:
•
Before performing the procedures described below, turn off system power and
disconnect all power plugs.
•
The server may weigh up to 48kg. Two people are needed to safely install the server
in or remove the server from the cabinet.
Improper handling by non-authorized personnel can cause serious damage.
•
Before servicing, you must ensure that the cabinet is level and secured with the
stabilizer to avoid tilting. Refer to the Bull 1100 & 1300 Cabinet Installation & Service
Guide, 86 A1 91EM for instructions on how to secure the cabinet.
Label affixed to the right side of the server drawer.
There are two types of rail bracket kits:
- simple rail bracket kit,
- combined rail bracket and cable arm kit.
B.2.3.1 Securing the Server Drawer with a Simple Rail Bracket Kit
On each side of the rack cabinet:
1. Position the front mounting bracket guide pins against the mounting flange holes.
2. Slide the rear-mounting bracket out of the front mounting bracket and position the
guide pins against the mounting flange holes.
3. Ensure that the mounting bracket is properly leveled.
4. Secure the mounting bracket to the mounting flanges, as follows:
Front side: one screw (M5x10), see Figure B-7a
Rear side : two screws (2 M5x10), see Figure B-7b
21-48 kg
Weight 21-48 (47-106 lb)
Can cause severe injury.
Lift with two or more persons.
Hold the bottom edge.
DO NOT grasp the side edge
CAUTION
Weight