Running with the Feeder Assembly
1.
Place the Feed Ramp Assembly onto the
Feed Ramp Holder. Align the holes on the
sides of the Feed Ramp Assembly to the
holes of the Feed Ramp Holder. (See figure
2.)
Attaching
the Feed
Ramp
Assembly
Figure 1
2.
Insert Quick Release Pin (See figure 1.) completely
through the all the holes and out the other side of the
Feed Ramp Holder. Press it in until the Ring is flush
against the side of the Holder.
3.
Raise the free end of the Feed Ramp Assembly up to a
nearly vertical position. (See figure 3.)
Figure 2
4.
On the bottom of the Feed Ramp Strut is the Wire
Form Adjustable Slide. Place the Slide with the
plunger onto the top of the Feed Ramp Adjustment
Bracket located on the side of the feeder. (See figure
4.)
Figure 3
5.
Pull the plunger out and lower the slide onto the
bracket. Release the plunger into one of the holes to
secure the Wire Frame Assembly in place. (See figure
5.)
Figure 4
Figure 5
Revision C
30K USERS MANUAL
Section 5 -
P/N
90-00203-001
4
Summary of Contents for 30K
Page 1: ...30K Ad dre ssi ng Pri nte r ...
Page 119: ......