Bryce 30K, User Manual, Page: 26 / 119

Printer Tips
When the correct numeral is selected the large line and the set
of 18 vertical lines form long vertical lines down the entire
Bank A of Print Heads.
Use the two Banks to print a return address and indicia on the
top of a piece with the addressee’s on the bottom with a USPS
barcode printed on the bottom. Or combine to two banks
together for single large block graphic with the address added
in.
Adjusting the
Banks Apart
Example : Use the following steps to adjust the 3
Print Head Assemblies apart.
1. Remove the Cover from the printer.
2. Loosen the knob on top of the bracket that
secures Bank A.
3. Move Bank A to the top of the piece for
return address and indicia.
4. Loosen the knob on top of the bracket that
secures Bank B.
5. Position the Bank near the middle of the
piece.
6. Move the Exit Rollers out of the area where Bank A
and Bank B are printing on the media. If the
Exit Rollers contact any printed information
on the media they will act as a brush with
paint and smear the print. Use the scale on
the shafts to help position the Banks.
7. Print out the Adjust Print test message. The
test shows the area where the banks will
print. Check if any of the exit rollers run
over the top of the print, move the rollers
over to a clear zone (non printing area of the
media) before continuing.
Revision C 30K USERS MANUAL Section 4 -
P/N 90-00203-001
8