Bryce 30K, User Manual, Page: 30 / 119

Printer Tips
Moving the
Wipers
The 3 Print Head Assemblies have several holes for relocating
the two narrow Wipers. Move the wipers when synchronizing
banks of print cartridges or when two or more banks of print
cartridges are printing near the same area or the Print Head
Assembly has to print on or near the edge of a piece of media.
Move the wiper(s) when it causes a problem while the media
is on the Transport Belts.
Pay special attention when using Bank A with Bank B
of Print Head Assemblies. If the wipers run over an
area on the media where ink was just sprayed the
print will smear or smudge. The area where ink is
sprayed onto the media is referred to as a Print Zone.
Use the markings located on the bracket of each Print
Head Assembly to judge where the Print Zone for
Bank B is located. Move the Wipers to an area
outside of the Print Zone to maintain the best print
quality.
Perform the following steps to move the Wipers:
1. Remove the Cover from the printer.
2. Loosen the knob on top of the bracket that
secures the Bank of Print Head Assemblies.
3. Flip the Bank of Print Head Assemblies upside
down to expose the bottom of the assembly.
4. Remove the two screws securing the Wiper(s) on the
Print Head Assembly (Bank A or
B).
5. Relocate one or both wipers away
from the Print Zone or edge of the
media. Reinstall the wiper(s) using
the two screws on each wiper.
Note : Move the Wiper(s) far off to the side
if one or both are running along the edge of
the piece or just off the edge. This may
cause skewing of the print or paper jams.
Revision C 30K USERS MANUAL Section 4 -
P/N 90-00203-001
12