Bandit
Copyright 1/10
PAGE
MODELS 65XP(XL)/95
DECALS
DECALS
Decals located on your Bandit equipment contain useful information to assist you in operating your
equipment safely. Some of the decals on your machine and their location are shown in this section.
It is very important that all decals remain in place and in good condition on your machine. Please follow the
care and instructions given below:
1) You should use soap and water to keep your decals clean. Never use mineral spirits or any
other abrasive cleaners.
) Replace immediately any missing or damaged decals. The location the decal is going to be
applied to must be clean and dry, and at least 40°F (5°C) before applying decal.
3) When the need arises to replace a machine component with a decal attached, be sure and
replace the decal.
4) Replacement decals are available, and can be purchased from the manufacturer or your
Bandit Dealer.
) Combination English / Spanish decals are typically standard. Other foreign language decals are
available and may be purchased. Mail translated decals required to Bandit Industries, Inc.
THE CLUTCH HANDLE SHOULD NOT
BE ENGAGED OR DISENGAGED AT
SPEEDS ABOVE 1000 RPM’S.
DO NOT operate this Clutch/PTO unless proper adjustments and
lubrication are maintained per the Clutch/PTO Manufacturer’s Manual.
Different brands and models require different service and operation
procedures. New Clutch/PTO’s require more
frequent adjustment.
GOOD OPERATORS
DON’T WASTE MONEY!
Clutches will fail, glaze over, and burn up from
improper adjustment. This will cost the owner of this
machine thousands of dollars to repair. A well
maintained, correctly adjusted clutch should function
properly for years.
EXAMPLES:
