Bandit
Copyright 1/10
PAGE 7
MODELS 65XP(XL)/95
MAINTENANCE SECTION
YEARLY CHECK LIST
O.K. Repaired
1) Change hydraulic oil and flush the hydraulic tank.
2) Replace hydraulic suction screen(s) annually or every 2000 hours.
WEEKLY CHECK LIST
O.K. Repaired
1) Check anvil clearance, tightness, and wear.
2) Check alternator and fan belts on engine.
3) Check spring tension on feed system.
4) Check and retighten wheel lug nuts.
5) Check and retighten fuel tank and hydraulic tank mount bolts.
6) Lubricate steel friction areas: pivoting, hinged, sliding, & rotating areas
(i.e. control handle, folding pan, discharge flipper, winch rollers, etc).
7) Use a dry lube on any chain driven component.
8) Grease chip box turntable bearing with 1 to 2 shots (if equipped).
3 MONTH CHECK LIST
O.K. Repaired
1) Replace hydraulic filter(s) after first 10 hours then quarterly or every 400 hours.
2) Grease swivel plates for discharge as needed.
3) Replace high pressure oil filter(s) (if equipped) after first 10 hours then quarterly
or every 400 hours.
WHEN YOU CHANGE CHIPPER KNIVES
CHECK CHIPPER DISC ASSEMBLY FOR
ELONGATED KNIFE BOLT HOLES, SECURE
WELDS, TORQUED BOLTS, EXCESSIVE WEAR
AND IMPACT CRACKS. IF A PROBLEM IS
FOUND CONTACT CHIPPER MANUFACTURER,
OR AN AUTHORIZED CHIPPER DEALER.
ALSO CHECK THE CHIPPER HOUSING AT
THIS TIME. CHECK BELLY BAND, BASE AND
HOODS FOR WEAR AND DAMAGE. ALSO
INSPECT THE CHIPPER BEARINGS.
MONTHLY CHECK LIST
O.K. Repaired
1) Check towing hitch for wear, keep pintle ring greased.
2) Check discharge, and infeed hopper for wear.
3) Inspect feedwheel motor connection.
4) Check feedwheel teeth for sharpness.
5) Check, retighten all bearing and chipper sheave bolts.
6) Check hydraulic function pressures. Set to specified PSI (bar).
7) Check and fill tires to rated pressure.
8) Check and grease or oil wheel bearings, follow axle MFG. instructions.
9) Check and adjust brakes, follow axle MFG. instructions (if equipped).
10) Check and adjust discharge chain tension (if equipped).
11) Lubricate “Bandit” lever throttle cable.
12) Check and retorque chip box turntable bearing bolts (if equipped).
