Bandit
Copyright 1/10
PAGE 7
MODELS 65XP(XL)/95
PROCEDURE FOR CHECKING OPTIONAL HYDRAULIC COMPONENTS
MODELS 65/95 PROCEDURE
HYDRAULIC SECTION
WARNING
MAINTAIN HYDRAULIC PRESSURE AT THE SPECIFIED PSI (bar).
YOKE LIFT CONTROL VALVE
YOKE LIFT
CYLINDER
FEEDWHEEL CONTROL VALVE
FROM PUMP
TO TANK
ALL OPTIONAL COMPONENTS
MAY BE CHECKED THIS WAY
GAUGE
PLUG
(OPTIONAL COMPONENT)
(VALVE FOR OPTIONAL
COMPONENT)
1. First put control handle in off position.
. Disconnect hose coming out of the port farthest from the handle of the control valve from the optional
motor or cylinder, and plug the hose.
. Leave all other hydraulic hoses connected.
. Install pressure gauge in the valve port which had the hose of the optional motor or cylinder disconnected.
. Start engine with the control handle in the off position.
6. Adjust engine to full throttle.
7. Only operate the valve for that component to activate pressure gauge. Pressure gauge should read the
maximum specified PSI (bar) for that component, see pages 64 - 65.
ONLY OPERATE VALVE FOR 4-5 SECONDS TO SET PRESSURE OR YOU MAY DAMAGE
HYDRAULICS.
8. Readjust relief pressure setting if needed, if not needed, shut off engine and remove plug and pressure
gauge. Reassemble control valve to optional motor or cylinder.
9. Check for hydraulic leaks.
10. Relief valve pressure should be checked and/or readjusted every month for best performance.
Before attempting any hydraulic pressure settings, make sure engine is shut off, engine key removed and in
your possession, hydraulic oil is clean, hydraulic tank is 7/8 full, and the machine has been pre-run to warm the
hydraulic oil. To correctly check relief valve pressure, gauge MUST
be installed correctly.
