BRP Lynx Rave 600RS 2020, Operator'S Manual

Page: 81 / 188

BASIC PROCEDURES
NOTICE
If vehicle does not move when throttle is applied, stop
engine, remove tether cord cap from the engine cut-off switch,
then do the following.
– Check if skis are stuck on the ground. Lift one ski at a time by
the handle, then put it down.
– Check if track is stuck on the ground. Lift rear of snowmobile
enough to clear track from the ground, then drop.
– Check rear suspension for hard snow or ice accumulation that
could interfere with track rotation. Clean the area.
CAUTION Beware of injuries by using proper lifting tech-
niques, notably by using the force of your legs. Do not attempt
to lift the rear of vehicle if it is above your limits.
WARNING
Make sure tether cord cap is removed before standing in front
the vehicle, getting close to the track or rear suspension com-
ponents.
NOTE: Warm-up is electronically controlled. During this period (up
to 10 minutes depending on ambient temperature), engine RPM is
limited.
Shutting Off the Engine
Release throttle lever and wait until engine has returned to idle
speed.
Shut off the engine using either the emergency engine stop switch
or by pulling off the tether cord cap from the engine cut-off switch.
WARNING
Always remove the tether cord cap from engine cut-off switch
when vehicle is not in operation in order to prevent acciden-
tal engine starting or to avoid unauthorized use by children or
others or theft.
__________________
79