BRP Lynx Rave 600RS 2020, Operator'S Manual

Page: 117 / 188

MAINTENANCE PROCEDURES
2. Open LH side panel, refer to
CONTROLS, INSTRUMENTS AND
EQUIPMENT .
3. Remove belt guard, refer to
DRIVE BELT GUARD REMOVAL
.
4. Keep the set screw from turning using a 1/8 inch Allen wrench
and loosen the lock nut using a 7/16 in open wrench.
5. Turn the set screw 1/4 turn at a time then rotate the driven pul-
ley to properly set the belt between the pulley sheaves. Measure
belt deflection using a straight edge and the tensiometer as ex-
plained below.
REQUIRED TOOL
TENSIOMETER (P/N 414
348 200)
6. Repeat until the right belt deflection is reached.
NOTE: Turn the set screw clockwise to increase the distance be-
tween the sheaves and counterclockwise to decrease the distance.
7. Tighten the lock nut after the belt adjustment has been made.
A32D34A
_________________
115