BRP Lynx Rave 600RS 2020, Operator'S Manual

Page: 116 / 188

MAINTENANCE PROCEDURES
Drive Belt Installation
1. If necessary, open the driven pulley, refer to DRIVE BELT RE-
MOVAL
above.
2. Slip the belt over the drive pulley, then over the driven pulley.
NOTICE
Do not force or use tools to pry the belt into place, as
this could cut or break the cords in the belt.
NOTE: The maximum drive belt life span is obtained when belt is in-
stalled with arrows in the direction of rotation.
mmo2011-002-006_a
1. To be pointed in the direction of rotation
3. Unscrew and remove the driven pulley expander from the pulley.
4. Rotate the driven pulley several times to properly set the belt be-
tween the sheaves.
5. If a new belt was installed, an adjustment will be required for the
proper belt height. Refer to DRIVE BELT ADJUSTMENT below.
6. Install belt guard, refer to
CONTROLS, INSTRUMENTS AND
EQUIPMENT .
7. Close side panel, refer to
CONTROLS, INSTRUMENTS AND
EQUIPMENT .
Drive Belt Adjustment
Drive belt adjustment must be performed every time a new belt is in-
stalled and as part of the pre-ride inspection.
To adjust the drive belt, proceed as follows:
1. Remove the tether cord cap.
114
_________________