III -
8
3) Head ASSY
CAUTION:
Before handling the head ASSY, take care not to touch it directly by hand.
The head ASSY may be damaged due to the static electricity charged in your body.
Remove the screw and take the head ASSY off the frame ASSY.
Figure 3.1-9 Removing the Head ASSY
n
Reassembling notes
• When setting the head ASSY to the frame ASSY, fit the two oblong holes provided in
the head ASSY over two positioning bosses on the frame ASSY and center those
bosses in those holes, as shown below.
• When setting the roller holder ASSY into place, first fit end "a" of the release spring in
guide groove "A" of the roller holder ASSY. Set the roller holder ASSY to the frame
ASSY and then hook end "b" of the release spring on cutout "B" as shown in Figure 3.1-
8.
• When securing the DC motor to the frame ASSY, orient it so that the motor leads is
routed in the direction shown in Figure 3.1-7.
Summary of Contents for PT 1000 - P-Touch 1000 B/W Thermal Transfer Printer
