III -
5
n
Reassembling notes
• When setting the cutter sensor arm and its spring back to the upper cover, first insert
spring end "x" into the hole provided in the cutter sensor arm and then fit them over the
pivot shaft as shown in Figure 3.1-4. Check that the cutter sensor arm moves smoothly.
• Before reassembling the bottom cover and upper cover, be sure to check that:
- the switch ASSY leads are taped to the bottom cover (position "a") and key PCB (two
positions "b" and "c") and that adhesive tape at position "a" prevents those leads from
routing over the ribs,
- the - terminal lead (black) is routed between the terminal press cover and bottom
cover and that the grounding wire (FG1) is routed beneath the - terminal lead,
- the motor loads are routed beneath the head flat cable,
- the head flat cable is taped to the frame ASSY with a slight curve, and
- the cutter lever is in the open position.
Reassemble the bottom cover and upper cover, taking care not to crush the flat cable
and lead wires between those covers.
Figure 3.1-5 Routing the Flat Cable and Lead Wires
Summary of Contents for PT 1000 - P-Touch 1000 B/W Thermal Transfer Printer
