III -
19
PRINT1 submode (5 key*)
(*You may switch back to this PRINT1 submode from any other submode by pressing the
5
key, except during the key depressing test in the KEY submode.)
With the "PRN1" displayed, the machine is in the PRINT1 submode.
Press the
key. The machine prints the test pattern as given below.
59.2 ±3 mm
The print length should be 59.2 ±3 mm.
After completion of printing, the machine automatically initializes the internal memory
and then turns itself off.
If the print length is out of the specified range, adjust the variable resistor on the
main PCB by using a flat screwdriver as shown below.
If the print length is longer or shorter, rotate the variable resistor for adjustment. After
the adjustment, print a test pattern again in the PRINT1 submode and confirm the
print length.
Figure 3.2-1 Adjusting the Print Length by Rotating the Variable Resistor
Summary of Contents for PT 1000 - P-Touch 1000 B/W Thermal Transfer Printer
