Brother PR-600, Manual

Page: 58 / 227

EMBROIDERING TUTORIAL ———————————————————————————————————————————————————
40
Thread the remaining needle bars in the same
way. However, if the needle bar to be threaded
is not moved to the sewing position, the needle
cannot be threaded with the automatic needle-
threading mechanism. For the remaining
needle bars, perform the following operation to
move the needle bar to the sewing position
before trying to thread the needle.
■
Moving the needle bar to be threaded to the
sewing position
1
Touch the key for the needle bar that you wish
to thread.
X
The selected needle bar moves to the
sewing position.
Note
●
If the thread is not taut, it may come out of
the thread tension disc. After upper
threading is finished, check again to make
sure that the thread is securely passed into
the thread tension disc. (Refer to step
5
on
page 37.)
Memo
●
When changing one of the upper thread
colors, it is easy to re-thread by cutting the
thread currently being used between the
spool and the thread guide. Place the new
spool on the spool pin and tie the end of the
new thread to the end of the previous
thread. Then pull the thread through to the
needle. (Refer to page 76.)
■
Using the spool net
When using metallic thread or any other strong
thread, place the included spool net over the
spool before sewing.
If the spool net is too long, fold it once to match
the size of the spool before placing it over the
spool.
It may be necessary to adjust thread tension when
using the spool net.
1 Spool net
2 Thread
2
1
Sapphire.book Page 40 Friday, August 1, 2003 9:12 AM