Brother MFC 5890CN - Color Inkjet - All-in-One, Service Manual

Page: 415 / 448

App. 4-41
Confidential
WSW36
(Function setting 14)
*ECP (Enhanced Capabilities Port)
Note: Selectors 2 and 3 on WSW36 take effect only when the "Monitoring the PC ON/OFF
state" is enabled with selectors 1 and 2 on WSW46.
• Selector 1: ECP mode
*
The ECP mode enhances the normal bidirectional communications between the machine
and the connected PC for higher transmission speed.
• Selector 2: Recovery from Inactive PC Interface
If the machine recognizes via the STB signal line that the connected PC is powered off, it
will turn the PC interface outputs Low to protect the PC from hazards that could be caused
by weak electric current accidentally flown from the machine.
This selector determines whether or not the machine should recover from the inactive PC
interface to normal interfacing state upon receipt of data from the PC.
• Selector 3: PC Power-off Recognition Time
This selector sets the time length from when the machine detects the PC powered off until
it recognizes the detected state as power-off.
If selector 2 is set to "0," it is recommended that selector 3 be set to "1"; otherwise, the
machine may mistakenly detect PC powered off.
• Selector 5: Escape from phase C
This selector determines whether or not the machine will escape from phase C when it
detects an RTC (Return to Control) in non-ECM mode or an RCP (Return to Control
Partial page) in ECM mode.
Selector
No.
Function Setting and Specifications
1 ECP mode* 0: ON 1: OFF
2
Recovery from Inactive PC
Interface
0: Disable 1: Enable
3 PC Power-off Recognition Time 0: Normal 1: Long
4 Not used.
5 Escape from phase C 0: Yes 1: No
6
|
8
Extension of incoming calling
signal (CI) frequency band
specified by selectors 1 through 4
on WSW14
No. 6 7 8
0 0 0 : 0 (Ignored)
0 0 1 : 4 (448 Hz)
0 1 0 : 8 (244 Hz)
0 1 1 : 12 (162 Hz)
1 0 0 : 16 (122 Hz)
1 0 1 : 20 (97 Hz)
1 1 0 : 24 (81 Hz)
1 1 1 : 28 (69 Hz)