Brother 882-W33, Operation Manual

Page: 89 / 216

PROJECTOR FUNCTIONS (UTILITY STITCHES AND CHARACTER/DECORATIVE STITCHES)
Se
w
in
g Ba
sics
87
2
g
With a chalk pencil, mark the fabric with
lines for sewing the stitch pattern and for
the end of stitching.
h
Affix an end point sticker, avoiding the
sewing area. Attach the end point sticker
within 4 cm (approx. 1-1/2 inches) to the
left or right of the chalkline where the end
point for sewing has been drawn.
a
4 cm (Approx. 1-1/2 inches)
i
Place the fabric in the machine, and then
lower the presser foot.
j
Press the "Start/Stop" button to start sewing.
When the foot controller is plugged in,
press down on the foot controller.
Gently guide the fabric to sew the stitching
straight.

The machine stops at the specified end point
automatically.
k
Peel off the end point sticker.
■
Temporary Stop Setting
If you cannot affix an end point sticker that avoids
the sewing area, you can adjust the machine settings
to temporarily stop sewing to allow the sticker to be
removed as you approach the end point sticker.
a
Select a stitch.
b
Touch , set [Temporary Stop] in the
machine settings screen to [ON], and then
touch .
c
Perform steps
c
through
f
in “Specifying
the Sewing End Point” on page 86.
Memo
• If [End Point Setting] is set to [ON], the stitch
pattern cannot be projected by the projector.
• To cancel [End Point Setting], set [End Point
Setting] to [OFF], and then touch .
Memo
• If the end point sticker can be affixed to either
left or right of the sewing position, we
recommend affixing it to the left side.
• We recommend affixing the end point sticker as
close as possible to the sewing position.
• If you cannot affix an end point sticker
avoiding the sewing area, refer to “Temporary
Stop Setting” on page 87.
• The horizontal guideline at the needle
indicates the distance from the stitching line
where the end point sticker can be affixed.
a 4 cm (Approx. 1-1/2 inches)
b
Guideline
Note
• Before sewing, make sure that the end point
sticker has not become detached. In addition,
make sure that the end point sticker is not
covered with your hand. Otherwise, the
machine cannot detect the end point sticker.
a a
Note
• While making sure that the guidelines align
with the lines drawn with the chalk pencil, sew
the stitching straight, not at an angle.
• Do not forcefully feed the fabric. Otherwise,
sewing may not stop correctly.
Memo
• If the stitch pattern could not be adjusted when
was set in step
f
, the following
message appears. Cancel [End Point Setting],
and then select a different stitch or change the
length of the stitch.