Brother 882-T51, Operation Manual

Page: 22 / 192

20
Setting up the machine
When setting up the machine, adjust the legs so
that the machine is steady.
a
Make sure that all packing tape affixed to
the machine is peeled off and that all
packing material is removed.
b
Set up the machine while making sure that
there is sufficient space around it.
c
Adjust the legs so that the machine is
steady.
Use the included wrench to loosen the lock nut on the
leg that you wish to adjust.
1 Lock nut
2
Adjustable foot nut
→
The foot can be turned.
d
Use the included wrench to turn the
adjustable foot nut on the foot.
Turning the nut in direction
1
lengthens the leg;
turning the nut in direction
2
shortens the leg.
1 Adjustable foot nut
• Adjust all four legs so that they securely contact the
desk or table.
e
After adjusting the legs to the desired
length, use the included wrench to tighten
the nuts.
1
Lock nut
f
Press down on each corner of the
embroidery machine to check that it is
stable.
If it is still unstable, perform steps
c
through
e
again
to adjust the legs.
More than
50 mm
(2 inches)
587 mm
(23-7/64 inches)
More than
350 mm
(13-3/4 inches)
More than
150 mm
(5-29/32
inches) 511 mm
(20-15/128
inches) More than
150 mm
(5-29/32
inches)