Always replace any damaged or worn parts with factory replacement parts.
l.
Always inspect the cables and hoses for cuts, burns, or any other signs of damage or wear.
m. Charge the lightweight battery.
n. Store the cutting torch kit in a clean, dry place.
INSPECT FLASH ARRESTOR AND SCREEN.
3-7. BATTERY CHARGING INSTRUCTIONS.
3-7-1. Charging the Lightweight Battery.
CHARGE A NEW BATTERY BEFORE USING.
CHARGE AFTER EACH SUBSEQUENT USE.
THE BROCO BATTERY MODEL PC/BISLW MAY TAKE UP TO 16 HOURS TO
FULLY CHARGE IF COMMENCING FROM A FULLY DISCHARGED STATE.
DO NOT STORE A RECHARGEABLE BATTERY IN A FULLY OR PARTIALLY
DISCHARGED STATE.
NOTE- BATTERIES MAY LOSE UP TO 3% OF THEIR CHARGE PER MONTH
DURING STORAGE.
Always disconnect power cables prior to charging the Lightweight Battery.
Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during
normal battery operation and there is a risk of these gases exploding. Never smoke or allow a spark
or flame in the immediate vicinity of the battery to reduce the risk of battery explosion.
The Lightweight Battery should never be left in a total discharged state for an extended period of
time. Damage could be permanent with poor performance as a result. When not in use, recharge at
least every two months.
Do not leave the Lightweight Battery on charge for more than 72 hours unless supplied charger is
marked as a “float” charger. Damage to the battery may result.
