11-2
COOKING CHAMBER PARTS
1. Press power OFF and disconnect main
power supply and allow cooking oil to
cool completely.
2. Open Access Door by raising Access
Door Latch and turn counter-clock-
wise. Lift door off hinges.
3. Remove Food Basket if present.
4. Remove Basket Lift
Platform.
5. Unlatch filter tray and pull tray out
(about 1.50”) with your free hand
under the tray and swing tray down
45
°.
6. With both hands pull tray out towards
you.
7. Remove Air filter and grease filter from
Filter Tray and set air filter aside so it
will not get wet.
Because the Air filter has
steam from the cooking process going
through it, let the Air Filter dry out over night
before reinstalling into the Filter Tray.
8. Raise Element by placing Element Arm
above Element Retainer.
9. Carefully remove Cooking Pot and fil-
ter oil or discard used oil properly.
10. Remove Splash Tray.
11. Wipe element guard and interior of
chamber with clean cloth or paper
towel to remove any crumbs.
Cooking oil may splash
while moved. Not allowing
cooking oil to cool completely could cause
serious burns.
DISHWASHER SAFE COMPONENTS
The Splash Tray, Product Door, Access
Door, Cooking Pot, Basket Lift Platform, Fil-
ter Tray and Grease Filter can be removed
from the unit and placed in a dishwasher.
DISHWASHER (DAILY)
1. Pre-rinse Splash Tray, Access Door,
Cooking Pot, Basket Lift Platform, and
Food Basket with hot water. Dislodge
any caked-on or stuck-on crumbs.
2. Place Splash Tray, Access Door, Cook-
ing Pot, Basket Lift Platform, Filter
Tray, Grease Filter and Food Basket in
dish washer for full cleaning and rinse
cycle.
3. Rinse Cooking Pot, Basket Lift Plat-
form, and Food Basket, with a vinegar
and water solution (1/2 cup vinegar
per gallon of water) to neutralize deter-
gent residue.
4. Wipe all surfaces of Cooking Pot,
Food Basket, and Basket Lift Platform.
Dry before filling with new oil.
5. Reinstall the Splash Tray and Cooking
Pot into the cooking chamber and
lower the Element into the Cooking
Pot. Then reinstall the Basket Lift Plat-
form, and Access Door
6. Reinstall grease filter into filter tray.
BE SURE
magnet end of grease filter
is on the right side when in place.
7. Reinstall air filter into Filter Tray with
arrows pointing up.
8. Reinstall Filter Tray into unit by tilting it
at 45
° and sliding it into the cabinet
as far as it will go at the 45° tilt.
broaster.com Manual # 16421 5/06 Rev 4/14
Summary of Contents for VF-2
