Instructions for Installation & Use
Instructions for Installation & Use
28
29
INSTALLING INTO VEHICLE REARWARD FACING
CONVERT TO REARWARD FACING MODE:
To fully recline the restraint, move recline foot by pulling
the recline foot handle and rotating to the rearward facing
position (refer to label on the side of the restraint) until
the handle locks into position. Ensure recline foot locks
into position.
The restraint is normally packaged in the fully upright forward facing mode. If you need to use it rearward
facing you must first fully recline the restraint. Convert the restraint to rearward facing mode by referring to
steps below.
NOTE: Ensure ISOFLEX connectors are removed from the storage location before reclining if ISOFIX low
anchorages are to be used.
Recline
position
indicator
Rotate
recline foot
to rearward
facing
position
HOW TO INSTALL - PREPARATION
HOW TO INSTALL - PREPARATION
B. Lift the flap at the end of the seat to
access the stabilising bar, pull out
stabilising bar and then gently push bar
forward until you hear a click. Stabilising
bar is now latched in place. Refit the
cover.
Lift cover enough to access
the stabilising bar
1
2
