Instructions for Installation & Use
Instructions for Installation & Use
64
65
IMPORTANT:
Always secure the loose end of the top tether strap to
prevent it hanging out of the car or being accessible by the child.
THIS RESTRAINT IS NOT SUITABLE FOR USE WHERE THE TOP TETHER
STRAP MAY FALL INTO A SPLIT IN THE SEAT BACK OR OFF THE SIDE
OF THE SEAT.
Car's Upper
Anchorage Fitting
Attachment Clip
Top tether storage
pocket
Top Tether
Adjustment Strap
Top tether strap
FORWARD-FACING
BELT PATH;
marked in
yellow.
Hook
Seatbelt
'Lock-off'
FORWARD FACING
BELT PATH;
marked in yellow.
Pull to remove
slack, then store
the strap in the
Pull to tighten belt
Front of
vehicle
HOW TO INSTALL USING ISOFLEX CONNECTORS
ISOFIX low anchors in the
vehicle rear seat
INSTALLING THE RESTRAINT INTO THE CAR
(USING ISOFLEX CONNECTORS IF SUPPLIED WITH THE CHILD RESTRAINT)
To prevent damage to vehicle seat it may be necessary to remove or open a trim covering the ISOFIX low
anchorages.
A. Locate the ISOFIX Low
Anchorages in the vehicle
rear seat. If you cannot locate
the ISOFIX bars, check your
vehicle owners manual.
The location may be
identified by one of the
following symbols.
C. Recline instructions are shown on page 59.
HOW TO INSTALL USING SEATBELT
B. With the restraint upright, remove both ISOFLEX
connectors from storage on the sides of the restraint by
unclipping the press studs and lifting the trim away. Then
remove the ISOFLEX connector by pressing the red button
on the connector and removing from the storage location.
