Instructions for Installation & Use
Instructions for Installation & Use
76
77
HOW TO REMOVE
REMOVE RESTRAINT FROM VEHICLE
FITTED WITH SEATBELT
A. Remove the top tether strap from pocket and fully
press top tether adjuster button (1) while pulling top
tether strap (2) to slacken as shown. In some vehicles
loosening of the top tether strap may be difficult. If so,
try pushing the restraint against the vehicle seat back or
slightly lifting the restraint to release the tension.
B. Disengage the attachment clip from upper anchorage
fitting.
C. Store loose strap in the top tether storage pocket
provided on the cover.
D. Disengage the vehicle seatbelt buckle from any lock-off
devices on both sides of the restraint.
E. Disengage seatbelt from the restraint belt paths. Allow
seatbelt to feed back into seatbelt retractor.
REMOVING CHILD FROM RESTRAINT
A. Push and hold the harness adjustment lever while
pulling both shoulder harness straps to slacken harness
to the desired amount.
B. Press the red button on harness buckle, both harness
tongues will be released. Insert buckle tongues into
harness tongue holders to hold harness straps away
from the child. Move each shoulder strap aside.
To remove the seat refer to page 77 for ISOFLEX or
below for seatbelt installation.
Harness
Tongue
Holders
Roll up excess
strap and store in
the pocket attached
to the cover to
avoid tripping
when moving the
restraint.
HOW TO REMOVE
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
2
REMOVE RESTRAINT FROM
VEHICLE FITTED WITH ISOFLEX
To store the ISOFLEX connectors on the inside of
the seat wings.
A. Press the ISOFLEX strap adjuster button to
release tension on the straps.
B. Press the red release button on each
ISOFLEX connector and remove them from
the vehicle ISOFIX low anchorages.
C. Adjust the ISOFLEX strap to the shortest
length and engage each ISOFLEX connector
onto its storage pin. Remove slack but do not
tighten. The storage pin may be damaged if
the strap is tightened.
Pull trim over ISOFLEX connector and clip
into press stud.
Push
Pin
