Instructions for Installation & Use
Instructions for Installation & Use
94
95
Extension Straps
Length 300mm (Use Britax Safe-n-Sound part 0035).
Length 600mm (Use Britax Safe-n-Sound part 0036).
Available from all major child restraint retailers.
Adjustable top tether
strap.
45
°
The shaded areas of this diagram illustrate the possible locations of the upper anchorage point (car anchor
fitting). Within each shaded area is an upper anchorage point showing the correct way to install the fitting.
Ensure the upper anchorage point is aligned as illustrated unless stated otherwise in the vehicle owner’s
handbook.
Measure distance from
restraint upper anchorage
attachment clip to the car
anchor fitting.
IF THE CAR IS FITTED WITH CHILD RESTRAINT
UPPER ANCHORAGE POINT
Locate the upper anchorage point behind the rear seating
position. (Consult the car owners handbook for the location of
the upper anchorage point). The upper anchorage point should
be directly behind and central to the restraint. Remove thread
plug from the parcel shelf/floor/roof, etc. and install attachment
bolt and fitting as shown in Fig 1.
CAUTION: DO NOT OVERTIGHTEN ATTACHMENT BOLT.
OVERTIGHTENING MAY FRACTURE OR BREAK BOLT.
MAXIMUM TORQUE IS 20 Nm(14.75 ft.lb.)
Note: Minimum of five full turns of attachment bolt is required
before tightening force is applied.
IF THE CAR IS NOT FITTED WITH CHILD
RESTRAINT UPPER ANCHORAGE POINTS
For Sedans only
- Drill 9mm diameter hole in the parcel
shelf on the centre line of the seating position as shown in Fig
3. Before drilling the hole, check the underside for accessibility.
Install the attachment bolt as shown in Fig 2. It is recommended
that this installation be carried out by a child restraint fitting
station or licenced motor mechanic.
For vehicles other than Sedans
- In Australia, consult
your nearest child restraint fitting station or traffic authority
for vehicle inspection to find the best, correct position for
the placement of the upper anchorage point, and for the
correct attachment bolt length and use of spacers. In New
Zealand, consult the agent for the vehicle. Note to Queensland
purchasers: The installation of anchorage points must be
approved by authorised officers appointed by Queensland
Transport. Authorised officers can be sourced from all
Queensland Transport Customer Service and Queensland
Ambulance Service Centres.
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle metal
structure
Reinforcing
washer (cone
downwards).
Lock washer
Secure nut
UPPER ANCHORAGE
FITTINGS FOR SEDANS ONLY
Vehicle trim
UPPER ANCHORAGE FITTING
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle metal
structure
Vehicle trim
Fig.1.
Fig.2.
INSTALLATION OF CAR'S UPPER ANCHOR FITTING
INSTALLATION OF CAR'S UPPER ANCHOR FITTING
Front of
vehicle
Front of
vehicle
