Instructions for Installation & Use
Instructions for Installation & Use
52
53
DISCONNECT TOP TETHER AND
ISOFLEX CONNECTORS
To store the ISOFLEX connectors on the inside of
the seat wings.
A. Press the ISOFLEX strap adjuster button to
release tension on the straps.
B. Press each of the red release buttons on the
ISOFLEX connectors and remove them from the
vehicle ISOFIX low anchorages.
C. Adjust the ISOFLEX strap to the shortest length
and engage each ISOFLEX connector onto its
storage pin. Remove slack but do not tighten.
The storage pin may be damaged if the strap is
tightened.
Pull trim over ISOFLEX connector and clip into
press stud.
Remove slack but do not tighten. The storage pin
may be damaged if the strap is tightened.
HOW TO REMOVE
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
2
HOW TO REMOVE
Stabilising
bar
Front flap
D. Remove the excess tether strap from pocket and fully
press top tether adjuster button (1) while pulling top
tether strap (2) to slacken as shown. In some vehicles
loosening of the top tether strap may be difficult. If so,
try pushing the restraint against the vehicle seat back
or slightly lifting the restraint to release the tension.
E. Disengage the attachment clip from upper anchorage
fitting.
Store loose strap in the storage pocket provided on
the cover.
F. Disengage the attachment clip from upper anchorage
fitting. The child restraint is now disconnected.
Store loose strap in the storage pocket provided on
the cover.
G. To store the stabilising bar, lift the front flap at the end
of the seat, this uncovers the stabilising bar storage
recess.
H. Press the blue button on left side (facing seat) and
gently push stabilising bar back and then down into the
recessed area.
I. Re-attach the seat pad at the end of the seat.
Then push
inwards
Button under trim
1
2
3
Rotate forward
E. Press the blue button on left side (facing seat) and
gently push stabilising bar back and then down into the
recessed area.
F. Re-attach the seat pad at the end of the seat.
Store instruction manual in pocket provided and tuck
pocket under trim cover.
Then push
inwards
Button under trim
1
2
3
Rotate forward
Press stud
attachment