4 Assembly and installation (to be
performed by the installer)
Assembly and installation should be performed by an installer approved by Brink Climate Systems B.V.
4.1 Assembly
You should perform the steps, described in paragraph (
®
Disconnecting the operational module from the wall
)
through paragraph (
®
Replacing the operational module in the wall bracket
page 10
)
, one by
one, to assemble the Brink Air Control- Ventilation.
4.1.1 Disconnecting the operational module from the wall bracket
Disconnect the operational module from the wall bracket. Perform the following actions :
▪
Slide the control unit upward over the two guide
profiles of the wall bracket until the control unit
can be taken off.
4.1.2 Mounting the wall bracket
The wall bracket can be attached to a wall box (Ø 55 mm) or can be directly mounted on the wall with screws and
plugs.
▪
Screw the wall bracket onto the wall in the correct
position. Here one must use the mounting holes in
the wall bracket.
Take note!
Consult (
®
page 7) for more information on placing the Brink Air Control-
Ventilation.
Brink Air Control- Ventilation 614884-B
Brink / 9
