3 Precautionary measures and
safety instructions
3.1 General
Warning!
The installation and assembly activities required to commission your Air Control - Allure clock
thermostat should be performed by an installer approved by Brink Climate Systems B.V.
Immediately remove the power from your Air Control - Allure clock thermostat by removing the
connected device’s plug from the socket, if:
▪
Parts of the Air Control - Allure clock thermostat lie open, are pierced or had fallen hard;
▪
The power cable is damaged;
▪
The screen is cracked or broken.
Then contact Brink Climate Systems B.V. or you supplier.
Take note!
▪
Never use parts other than original parts.
▪
Only use the Air Control - Allure clock thermostat indoors, at temperatures between 0 °C
and 50 °C and with a relative humidity between 0% and 90%.
▪
All settings (excluding the filter message) will be lost if the Air Control - Allure clock
thermostat breaks down or if the factory settings are reset. There is no backup available.
3.2 During placement
Take note!
Assembly and installation should be performed by an installer approved by Brink Climate
Systems B.V. The following requirements should be taken into account during placement:
▪
The Air Control - Allure clock thermostat should be placed at a height of approximately 1.65
meters above the floor;
▪
The Air Control - Allure clock thermostat may not be covered, for example, by a curtain or a
cabinet;
▪
Consult paragraph
®
page 4 for environmental requirements.
3.3 During use
Take note!
Settings, which have not been described in this user’s manual, are intended for installers
approved by Brink Climate Systems B.V.
Do not change these by yourself.
Air Control - Allure clock thermostat 616720-A
Brink / 7
