3 Precautionary measures and
safety instructions
3.1 General
Warning!
The installation and assembly activities required to commission your Brink Air Control-
Ventilation should be performed by an installer approved by Brink Climate Systems B.V.
Immediately remove the power from your Brink Air Control- Ventilation by removing the
connected device’s plug from the socket, if:
▪
Parts of the Brink Air Control- Ventilation lie open, are pierced or had fallen hard;
▪
The power cable is damaged;
▪
The screen is cracked or broken.
Then contact Brink Climate Systems B.V. or you supplier.
Take note!
▪
Never use parts other than original parts.
▪
Only use the Brink Air Control- Ventilation indoors, at temperatures between 0 °C and 50 °C
and with a relative humidity between 0% and 90%.
▪
All settings (excluding the filter message) will be lost if the Brink Air Control- Ventilation
breaks down or if the factory settings are reset. There is no backup available.
3.2 During placement
Take note!
Assembly and installation should be performed by an installer approved by Brink Climate
Systems B.V. The following requirements should be taken into account during placement:
▪
The Brink Air Control- Ventilation should be placed at a height of approximately 1.65 meters
above the floor;
▪
The Brink Air Control- Ventilation may not be covered, for example, by a curtain or a cabinet;
▪
Consult paragraph
®
page 4 for environmental requirements.
3.3 During use
Take note!
Settings, which have not been described in this user’s manual, are intended for installers
approved by Brink Climate Systems B.V.
Do not change these by yourself.
Brink Air Control- Ventilation 614884-B
Brink / 7
