Page 76 of 84
040-57105-01
5
UI & MODEM Update Procedures via CLI
Tools and Methods
Tools and equipment needed for software update
PC or laptop with telnet or SSH enabled
Ethernet cable to connect to the ra
dio
UI Software Update Package
The factory default IP addresses for the FLEX4G-LITE V² are:
Low Band: 10.100.7.247
High Band: 10.100.7.248
If the IP address of the target radio was previously changed, use
that address along with user ID and password where required.
Update Using Command Line Interface
This method requires a Telnet connection from the host PC to the radio. In
addition, a TFTP server is required to host the new UI package.
Follow this step to perform the update:
1.
Copy the FLEX4G-LITE UI upgrade file to a known location on the
host PC. The upgrade file extension ends with “.gz”
2.
Start a TFTP server (NBTFTP.exe) on the host PC.
3.
Set the search directory of the TFTP server to the directory where
the upgrade software is located.
4.
Open a Command window on the host PC.
5.
Telnet to the target FLEX4G-LITE radio by typing at the system
prompt:
6.
C:\>telnet <ip_addr>
7.
Connection should establish and the radio will respond with a
request for the Username. Enter “admin”. A request for
password will follow. The default password is <enter> or return
on the PC keyboard.
8.
The FLEX4G-LITE will send a message with the number of error
entries in the syslog and then display a prompt.
