Page 49 of 84
040-57105-01
o
1Gbps FDX
–
Forces the port to 1000Mbps full duplex
o
SFP_Auto_AMS - Automatically determines the speed of the
SFP. NOTE: There is no standardized way to do SFP auto detect,
therefore, the SFP rom read to determine the speed.
The port is set in AMS mode. Cu port is set to Auto mode.
100
–
FX
–
SFP port in 100-FX speed. Cu port disabled.
100
–
FX_AMS
–
Port in AMS mode. SFP port in 100-FX speed. Cu
port in Auto mode
1000-X
–
SFP port in 1000-X speed. Cu port disabled.
1000-X_AMS
–
Port in AMS mode. SFP port in 1000-X speed. Cu port
in Auto mode.
Ports in AMS mode with 1000-X speed has Cu port
preferred
Ports in AMS mode with 1000-X speed has fiber port
preferred
Ports in AMS mode with 100-FX speed has fiber port
preferred
Flow Control: When Auto Speed is selected on a port, this section
indicates the flow control capability that is advertised to the link
partner. When a fixed-speed setting is selected, that is what is used.
The Current Rx column indicates whether pause frames on the port are
obeyed and the Current Tx column indicates whether pause frames on
the port are transmitted. The Rx and Tx settings are determined by the
results of the last Auto-Negotiation.
NOTE: Check the configured column to use flow control. This setting is
related to the setting for Configured Link Speed.
Maximum Frame Size: Enter the maximum frame size allowed for the
switch port, including FCS. The range for this field is 1518 – 9600
bytes.
Excessive Collision Mode: Configure port Transmit collision behavior.
Available options:
Discard: Discard frame after 16 collisions (default)
Restart: Restart back off algorithm after 16 collisions
Save Button: This buttons must be click to save the new settings
before moving to another page.
