Page 19 of 84
040-57105-01
Channel Bandwidth: Pull down menu allows the user to select the
operating channel bandwidth, if licensed, from the pull down menu.
Channel Frequency: Input the Transmit Frequency in MHz for which this
radio is assigned. Valid frequencies must be divisible by 62.5MHz.
ODU Polarity: This field not configurable. However, the field will display the
current polarity the unit is on.
ATPC or Alignment: Select “ATPC” or “Alignment” from the next pull down
menu. “Alignment” should only be selected for use during the alignment
procedure as it will fix the transmit power per the value set in the Alignment
TX Power box. The radio must be set to ATPC after the link is properly
aligned for normal operation.
Min TX Power and Max TX Power: Enter the Minimum and Maximum
Transmit ATPC power levels. Allowable range is from -5 dBm to +22 dBm.
This feature only works with ATPC is selected.
Alignment Tx Power: Enter a specific transmit power value. This feature
only works when Alignment mode is selected.
Mute: Enable Mute to stop RF Transmission of the local radio. The Mute
Timeout value is configured under the Configuration page. The default
value is 10 mins.
CW: Disables transmitter modulation and sends a constant carrier out the
antenna port for tests requiring an unmodulated signal.
Minimum and Maximum Bit Rate: Selects the allowable minimum and
maximum bit rates from the pull down menus. This must be done in order for
Adaptive Coding and Modulation to operate. The maximum bit rate is
controlled by the license key installed on the Licensing page.
CPRI (Port 2): Select the CPRI speed from the pull down menu. The range
available is: 614.4Mbps – 3.072Gbps.
Setting the Radio’s IP Address
Radio IP Address can be changed by selecting the following link from
the Navigation pane:
Switch>Configuration>System>IP in the Navigation Panel.
This will open the following screen.
