Brew-Boss® V2.06 Operation Manual
Swirl-Boss Whirlpool Wand Instructions
The Swirl-Boss wand is designed to connect to a 1/2” ID silicone brewery hose. Simply slip the hose
coming from your pump over the end of the wand. A hose clamp should not be needed, but you may
add one if you feel it is necessary.
Loosen the clamp bolt enough to allow the clap to be slid over the edge of the kettle. Tighten the clamp
finger tight just enough to slightly compress the plastic end cap on the screw (do not use tools). Adjust
the wand so the top leg of the “E” shape nozzle is just above the surface of the wort. To adjust the
level, simply slightly loosen the wing not on the clamp and slide the wand up or down and then tighten
in the appropriate location. The vertical portion of the “E” nozzle should be positions so it points
parallel with a line tangent to the diameter of the kettle at that point (see the picture above that shows
the flow arrows exiting the wand). The special “E” nozzle will direct flow along the perimeter of the
kettle as well as slightly inward to optimize rotation. You loosen the clamp and rotate the wand to get
your best whirlpool rotation speed.
Run the pump at fill output (restriction valve open all the way). We've found about 10 minutes is
optimum for effective sediment concentration to the center of the kettle. The nozzle is designed to
aerate the wort as well, but if you do not want the aeration, simply lower the wand so the entire “E”
nozzle is beneath the surface of the wort.
Page 69
