Page 32
1-03 Update
Perform all procedures listed in previous section also
3 Mo
nt
hs
or
1200
Cycles
Roll stop foot pivot bearings (Item 3)
Upper/lower fold arm telescoping area (Item 8)
Platform pivot pin bearings (Item 9)
Platform fold axle bearings (Item 10)
Inboard barrier lever bearings (Item 11)
Inboard barrier lever slot (Item 12)
Platform fold pin bearings (Item 13)
Rotating pivot slide arm pivot pin (Item 14)
Parallel arm pivot pin bearings (Item 15)
Handrail pivot pin bearings (Item 16)
Hydraulic cylinder bushings (Item 17)
Lower fold arm block bearings (Item 18)
Inspect Lift-Tite
™
latch catch rollers (Item 19) for
wear or damage and positive securement
Inspect outboard roll stop feet (Item 2) for proper
operation, positive securement, and detached or
missing torsion spring
Inspect inboard roll stop for:
• Wear or damage
• Proper operation
• Positive securement (both ends)
Inspect handrail components for wear or damage,
and for proper operation
Inspect platform fold gears for wear, damage or
foreign objects
Check adjustment of platform sensor (fold) switch
(pump mounted hydraulic pressure switch)
Inspect platform fold pins and bearings for wear or
damage and positive securement.
Inspect microswitches for securement and proper
adjustment.
Make sure lift operates smoothly
Inspect inboard roll stop operation. Roll stop should
just rest on the top surface of the base plate.
Apply Light Grease - See Lubrication Diagram
Apply Light Grease - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Correct, replace defective parts and/or relubricate.
Correct or replace defective parts and/or
relubricate. See Lubrication Diagram
Resecure, replace or correct as needed. See
Platform Angle Instructions, Floor Level Guideline
Adjustments and Fold Arm Adjustments.
Replace defective parts.
Remove foreign objects from gears and replace as
needed.
Adjust or replace as needed. See Systems
Descriptions for details and procedures.
Replace defective parts and resecure as needed.
Resecure, replace or adjust as needed. See
Systems Descriptions for Microswitches.
Realign towers. Lubricate or correct as needed.
Adjust microswitches as needed. See Floor Level
Guideline Adjustments and Fold Arm Adjustments.
M
aint
e
nan
ce
an
d Lu
b
r
i
c
ati
o
n
Schedule
continued
