Page 62
Lift Model
Lift Weight
The following specifications are basic to the electrical/hydraulics operations. Further technical specifications
and details of components are provided in the
Systems Descriptions
and
Troubleshooting
sections
located within this manual.
VL917IB
380 lbs
Lift Specifications
Platform Unfold (Out)
- Platform unfolds from fully-stowed position to floor level position
Platform Lower
- Platform only (with 400 lb. load) lowers from floor level position to fully-lowered (ground
level) position
Platform Raise
- Platform only (with 400 lb. load) raises from fully-lowered (ground level) position to floor
level position (fully raised) position
Platform Fold (In)
- Platform folds from floor level position to fully-stowed position
2. A 400 pound platform load used in all Lower and Raise operations.
3. Fully charged 12 volt DC power source. Low voltage will moderately affect test results.
4. The Length of Travel dimensions reflect the Maximum Floor-to-Ground dimension for the particular lift
models specified in the Operations Cycle Time Charts.
Note:
The Length of Travel dimension will vary
with differing lift installation vehicle floor heights. All figures must be calculated per your particular Length
of Travel (floor-to-ground) dimension when comparing.
1. Environmental temperature of 72
°
F. Extremely low temperatures can moderately affect cycle time.
Operational Specifications:
The performance data contained within the Operations Cycle Time Charts on page 63 provide general
performance criteria. This information is compiled from tests conducted on
standard
VL917 Series lift
models meeting the following
constant
operational specifications.
Operations Cycle Times
Operation Descriptions:
Note:
Lift weights applicable for rear and front pump lift models.
The Lift Series Code:
See the lift-posted Serial
No./Series No. Identification tag.
Hydraulic Pump:
M258 factory-equipped
with
a
manual Backup Pump (hand pump).
Hydraulic Fluid:
Dextron III automatic transmis-
sion fluid. Further hydraulic fluid specifications
are provided in the Systems Descriptions section.
Hydraulic Pump Pressure Relief Valve Setting:
M258 is factory set at
2100 psi. Note:
See
Systems Descriptions for adjustment procedures.
Design Lifting Capacity:
800 lbs.
Pump Identification Codes:
12 volt - 33 and
24 volt - 34 (at time of publication - see lift-posted
Serial No./Series No. Identification tag if in doubt).
Power Source:
12 VDC battery with negative
ground
(Standard
Lift Models).
Note:
Special
applications powered by 24 volt system.
