Page 20
Lift Installation Instructions
5
Control Box and Harness Installation
Control Box
Harness Socket
Groove
Guide
2
3
Pump
Module
Drill 1/8" diameter mounting holes or
use nut driver bit to install self-taps
Figure Q
Back Plate
Clip Bracket
Burr edge toward
mounting surface
Quick-Disconnect Harness:
“Quick-disconnect”
hand-held controls are available with four types of
cable (standard, armored and coiled). VL917 Series
lifts are shipped without the control box harness
installed. All harnesses are equipped with the same
quick-disconnect sockets. Remove the control box
and harness from their packing and connect as
stated below.
Harness Installation (Connect) Instructions
1.
Align control box harness socket guides with
pump module socket grooves (will only connect
one way).
2. Carefully
insert control box harness socket in
module socket.
3.
Turn control harness socket
inside
knurled grip
clockwise fully.
Harness Removal (Disconnect) Instructions
Reverse Steps 2 and 3 above.
Self-tap
Screws
Note:
Position the smooth-edged surface
of back plate
out
(surface with burr edge
against the mounting surface).
Module-mounted
9-pin Socket
