www.babyqs.com
BZC123
Grupo 1/2/3
Sistema de retención infantil
24
Child restraint system
2.
The harness should be as tight as possible without causing
discomfort to your child.
3.
Make sure the lap section of the harness is positioned as low
as possible, surrounding your child’s hips and not his stomach.
4.
A harness that is not properly tightened can be dangerous.
Check the harness adjustment and tighten whenever you put
your child in the child safety seat.
Loosening the harness
1.
The harness is loosened by pressing the adjustment button of the
harness (under the seat cover) at the front of the seat. (5.12)
2.
Press the lever that is marked with “
press
” down with one hand
while holding both harness straps with your other hand.
3.
Pull the harness straps towards you to loosen the harness.
4.
Be careful when adjusting the harness strap not to trap the
harness adjustment strap when you press the button down.
25
www.babyqs.com
7. CLEANING AND MAINTENANCE.
WASHING INSTRUCTIONS:
· The cover is removable and washable at
30º. Dry in the fresh air only.
· Wash in washing machine (cold).
· Do not use bleach.
· Dry clean, with any solvent except
trichloroethylene.
· Do not use dryer.
· Do not iron.
1.
Wash the straps and plastic parts with neutral detergent and
warm water.
2.
Ensure that no soap enters the buckle or metal parts.
3.
Do not use chemicals or bleach on any part of the chair.
4.
Dry thoroughly before use.
If you have any question about using or installing this product, or if you need
a spare part contact our Customer Service.
Cleaning the seat
6. SEAT AND HARNESS REMOVAL.
Remove the seat harness
1.
From the back of the seat, unhook the
N
harness protector
connector tapes and detach the harness from the metal
connector of
Q
harness, pull the
Q
connector tape to detach
completely from the seat 6.1, 6.2 and 6.3).
Remove the cover buckle protector and the lower harness
1.
Pull the base tape to detach it from the seat (6.4).
2.
Turn the plate attached to the safety buckle so that they coincide
with the nearest slot and insert into the slots of the seat base and
then pass through the slots in the cover (6.5).
EN
BZC123
Group 1/2/3
