60
en | Installing the In-Ceiling Mount
AutoDome 600 Series Analog PTZ Camera
F.01U.265.793 | 2.0 | 2012.02
Installation Manual
Bosch Security Systems, Inc.
5.
Tighten the four (4) securing screws to the Bracket Assembly.
Figure 4.4
Tighten Bracket Securing Screw
6.
Secure the Bracket Assembly to an overhead securing point with a safety wire.
Figure 4.5
Secure Bracket Assembly
4.6
Wire the Interface Box
The Interface Box can be wired through the top or side. Use the supplied rubber plug to seal
the hole which will not be used to route wires.
4.6.1
Make the Connections
After routing all video, control, power, and alarm wires:
1.
Attach a 3/4-inch NPS (20-mm) conduit fitting to the hole in which you bring in the wires.
Be sure to thread the inside nut to the conduit fitting.
2.
Route the video, control, power, and alarm wires through the conduit fitting and into the
Interface Box.
3.
Cut and trim the wires allowing for sufficient slack to their respective terminals in the
box.
4.
Attach the remaining control data in/out wires to their respective terminals in the
Interface Box. Refer to
Table 4.1, Page 63
, for terminal connections.
NOTICE!
If installing the dome to a drywall ceiling, allow enough wire to make the connections in the
Interface Box below the ceiling. Refer to
Figure 4.7
, for connector locations and
Table 4.1,
Page 63
, for wire connections.
Summary of Contents for VG5 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera VG5 600 Series en Installation Manual ...
Page 2: ......
Page 87: ......
