AutoDome 600 Series Analog PTZ Camera
Installing the In-Ceiling Mount | en
63
Bosch Security Systems, Inc.
Installation Manual
F.01U.265.793 | 2.0 | 2012.02
The following table summarizes the pin connectors and their function:
Table 4.1
Interface Box Wire Terminals
4.7
Prepare Bubble
The inside of the housing contains packing material to safeguard the camera during shipping.
You must remove the packing material before attaching the in-ceiling housing to the interface
box.
To remove the Bubble:
1.
Loosen the lockscrew (item 1 in the illustration below) in the trim ring using a P1 or
smaller Phillips screwdriver until the bubble can rotate freely.
2.
Then rotate the bubble counterclockwise approximately 1/4 turn until it releases from
the In-Ceiling Housing. See the figure below for an illustration.
Figure 4.8
Bubble Release Screw
3.
Remove the foam inserts surrounding the camera module.
4.
If you plan to use the RS232 or the RS485 protocol to control the dome, refer to either
Section 5.4.2 Controlling the AutoDome via the RS232 Protocol, page 71
, or
Section 5.4.3 Controlling the AutoDome via the RS485 Protocol, page 72
, for instructions.
Then, proceed to the next step.
No.
Connector
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
P103 Alarms In
Alarm 3
Alarm 4
Alarm 5
Alarm 6
Alarm 7
AGND
P102 Alarms Out
Alarm 1
Alarm 2
Alarm 3
GND
P104 Analog Relay
Relay
N.O.
Relay
COM
Relay
N.C.
Earth
Alarm 1
Alarm 2 Ground
P105 Data In/Out
C-
(BiPhase)
C+
(BiPhase)
Earth
Ground
RXD (+)
(RS-232/485)
TXD (-)
(RS-232/485)
Signal
Ground
P101 24 VAC
Line
Earth
Neutral
J102
Video BNC
Connector Input
J101
UTP/Ethernt
(Ethernet for VG5
700 Series only)
Connector Input
WARNING!
24 VAC Class 2 power supply only.
Summary of Contents for VG5 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera VG5 600 Series en Installation Manual ...
Page 2: ......
Page 87: ......
