AutoDome 600 Series Analog PTZ Camera
Installing the Roof Parapet and Pipe Mounts | en
43
Bosch Security Systems, Inc.
Installation Manual
F.01U.265.793 | 2.0 | 2012.02
3.4.3
Wiring the Fiber Optic Model
1.
If installing a Fiber Optic model, bring the fiber optic cable into the right side of the
power supply box.
2.
If installing a Fiber Optic model attach the incoming ST fiber plug, installed previously, to
its mating connector on the Fiber Optic Module in the power supply box. Refer to
Section 5 Cable and Wire Standards, page 67
for fiber optic specifications.
3.
Route the control wires from the Power Supply to the Pipe Interface Board. Then attach
the supplied six (6) pin control data connector to the wires in the Power Supply Box.
NOTICE!
You will need a barrel connector (not supplied) to connect the BNC connector from the Pipe
Interface Board coax cable to the Fiber Optic Module BNC connector.
1
Transformer
5
In/Out
2
BNC to Dome
6
ST Connector (Fiber)
3
In/Out
7
Power In
4
From Arm Harness
8
Data In/Out
(GND)
GND TXD
RXD
C+
C-
(FUSE)
(FUSE)
(FUSE
)
24V NC 24V
HTR DOME
Summary of Contents for VG5 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera VG5 600 Series en Installation Manual ...
Page 2: ......
Page 87: ......
