702_58300000170749_ara_en_c
Page 74 of 82
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
6.2
Customer service test program
6.2.1
Entering the customer service test program
•
If the dishwasher needs to be reset, turn it on and off
again. The dishwasher must be off to enter the program.
•
While pressing and holding both the “
B
” and “
C
” buttons
(below)
, press and hold the
On / Off
button (to turn the
dishwasher on) until the display shows “
P0
”. Release all
buttons.
•
To enter the customer service test program, press the “
B
”
button once – the display will show “
P1
”.
6.2.2
Running the customer service test program
•
Press the “
C
” button
(below)
to start the customer service
test program.
•
The program shows test step #’s (“
S:00
–
S:22
”)
o
For test steps, including values to be checked, see
Viewing test program
6.2.4.
o
To skip test steps, press the “
B
” button.
o
Only the following steps can be skipped.
S:11
heating / circulating
S:14
heating / circulating / moving water
switch
•
Running the customer service test program clears error
codes.
•
Test steps can vary a bit, depending on the dishwasher
model.
6.2.3
Exiting the customer service test program
•
Reset the test program by pressing and holding the
Start
button for three (3) seconds. The display will show “
0:01
”.
•
Turn the dishwasher off to exit the program.
