702_58300000170749_ara_en_c
Page 37 of 82
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
1. Remove six (6) short T-20 Torx inner door screws below
fascia panel – three per side
(below, left)
.
2. Carefully pull bottom of outer door out from dishwasher
until top door tabs clear, then pull door down until it
releases from dishwasher
(below, right)
. Take care to not
scratch outer door.
TIP:
Outer doors with foam door guards don’t need door
guards removed unless doors are being replaced.
WARNING:
Removing / installing outer doors can cut
fascia panel wire harnesses (i.e. to on/off switch, control or
dispenser), causing short circuits that can damage controls or
cause electric shock.
•
Remove / install outer doors carefully to insure harness
wires and insulation aren’t cut.
•
After removing outer doors, check wires and insulation
to make sure they’re not cut or pinched.
5.1.2.2 To remove door handle (SHX models)
Tools needed: T20 Torx & flat blade screwdrivers.
1.
Remove outer door
– section 5.1.2.1.
2. To remove handles from outer doors, remove two (2)
screws and washers from the inside of the door
(below)
.
3. Unscrew endcap set screws to separate endcaps from the
handle.
5.1.2.3 To remove pocket door handle (certain SHP models)
Tools needed: T20 Torx & flat blade screwdrivers, pliers &
gloves.
1.
Remove outer door
– section 5.1.2.1.
2. Unscrew three (3) screws on the inside of the outer door
attaching the pocket handle to the fascia panel
(below left)
.
3. Carefully pry door flanges away from the tabs on the top
and bottom of the dispenser.
