8/56
Press modules Type IH04
| Safety instructions
Bosch Rexroth AG, Edition 08.2021, RE 63124-B
2 Safety instructions
2.1 About this chapter
The press module was designed and manufactured according to the generally
accepted code of practice. However, there is still the danger of personal injury
and damage to property if you do not observe this chapter and the safety
instructions in this documentation.
▶ Read this documentation completely and thoroughly before working with
the press module.
▶ Keep this documentation in a location where it is accessible to all users
at all times.
▶ Always include the required documentation when you pass the press module
on to third parties.
▶ Additionally, please observe the safety instructions for the overall
machine/system.
The safety instructions in these instructions only refer to the scope of delivery.
Due to the interaction between the press module and the overall machine/system,
the installation of the press module into the machine involves additional hazards.
This applies in particular to the influence of hydraulic and electric controls on
hydraulic drives which generate mechanical movements. It is therefore essential
for the manufacturer of the overall machine/system to have undertaken an
independent risk assessment. Furthermore, the manufacturer must on this basis
have prepared operating instructions for the overall machine/system.
These operating instructions do not serve as replacement of the operating
instructions of the overall machine/system.
2.2 Intended use
The product is a hydraulic control block. It is intended for use in industrial machines
only. You may use the product as follows:
• in a hydraulic press according to ISO 16092-1, par. 3.1 and plastic presses
according to EN 289, par. 3.1, designed or intended to transfer energy hydraulically
by a vertical linear movement between closing upper and lower dies
• complying with the application and environmental conditions according to the
relevant data sheet
• complying with the specified performance limits according to the circuit diagram
and the relevant data sheet
• use in the original condition and/or without damage.
All operating modes such as automatic mode, single stroke and set-up/jog mode
with slow closing speed (<10 mm/s) are allowed. They work according to a fixed
working cycle specified in the type-specific data sheet.
