17/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
Press Enter and the screen to the left will appear.
•
Using the Down navigation button to move the cursor in front of “XXXX0” and
press the Enter button.
•
Using the Left or Right navigation button, move the cursor under the number to
be changed.
•
Using the Up or Down navigation button, change the number as required.
•
Once all the numbers have been changed, press the Enter button.
•
Press the Escape button three (3) times to return to the first screen.
4.1.2
4.1.2
4.1.2
4.1.2 Auto C
Auto C
Auto C
Auto Calibration Using a Hand Held GPS Unit
alibration Using a Hand Held GPS Unit
alibration Using a Hand Held GPS Unit
alibration Using a Hand Held GPS Unit
Follow the auto calibration procedure below, hold the vehicle speed to the speed
indicated on the hand held GPS unit.
4.1.3
4.1.3
4.1.3
4.1.3 Auto C
Auto C
Auto C
Auto Calibrati
alibrati
alibrati
alibration Using the GPS Provider’s Ground Speed Signal
on Using the GPS Provider’s Ground Speed Signal
on Using the GPS Provider’s Ground Speed Signal
on Using the GPS Provider’s Ground Speed Signal
Follow the auto calibration procedure below, hold the vehicle speed to the speed
indicated on the GPS provider’s system. Note: cell phone communication with the
GPS provider will be necessary.
4.1.4
4.1.4
4.1.4
4.1.4 Auto C
Auto C
Auto C
Auto Ca
a
a
alibration Using the Vehicle’s Speedometer
libration Using the Vehicle’s Speedometer
libration Using the Vehicle’s Speedometer
libration Using the Vehicle’s Speedometer
Follow the auto calibration procedure below, hold the vehicle speed to the speed
indicated on the vehicle’s speedometer.
4.1.5
4.1.5
4.1.5
4.1.5 Auto Calibration Procedure
Auto Calibration Procedure
Auto Calibration Procedure
Auto Calibration Procedure
Select “SENSORS AND VALVES” and select “GRND SPD SENSOR”. The screen to the
left will appear.
Using the navigation button move the cursor to the “AUTO CALIBRATION” and press
the Enter button. The screen to the left will appear.
Press Enter and set the speed at which you will be driving during the calibration
process.
Use the Right or Left navigation button to move the cursor under the number to be
changed, use the Up or Down navigation buttons to set the speed. Once the speed
has been set, press the Enter button.