16/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
calibration process the CS-440RC will determine the pulses per KM or Mile; this
count will be reflected on the “Speed input” screen once the auto calibration
process has been completed.
4.
Auto-calibration to the vehicle’s speedometer. By driving the vehicle at a
predetermined speed using the vehicle’s speedometer as the speed indicator.
The accuracy level is only as accurate as the speedometer calibration. During the
calibration process the CS-440RC will determine the pulses per KM or Mile; this
count will be reflected on the “Speed input” screen once the auto calibration
process has been completed.
4.1.1
4.1.1
4.1.1
4.1.1 Driving the Vehicle Over a Measured Distance
Driving the Vehicle Over a Measured Distance
Driving the Vehicle Over a Measured Distance
Driving the Vehicle Over a Measured Distance
Accurately measure out a distance of one (1) KM or one (1) Mile on a low traffic
volume section of road and mark the starting and end point with clearly visible
markers.
•
Drive the vehicle to the starting point and stop with the vehicle’s front bumper
in line with the marker.
•
On the CS-440RC, press the Escape button. (The programming key is not
needed for this.)
•
With the cursor arrow pointing at “Trip Summery”, press Enter.
•
The top line of the transaction screen will reflect “XXXXX KM/Mile Total Dist”.
•
Press the Escape button to leave the Trip Summery screen and press the
Escape button again to re-enter.
•
With the cursor arrow pointing at “Transaction screen”, press Enter.
•
The top line will now read “XXXXX Pls Total dist.”
•
Press the Enter button to reset all values to Zero (0).
•
Drive the vehicle over the measured KM/Mile and stop with the front bumper in
line with the End point marker.
•
On the CS-440RC, press the Escape button. (The programming key is not
needed for this).
•
With the cursor arrow pointing at “Trip Summery screen”, press Enter.
•
The top line will now read “XXXXX Pls Total dist.”, write down the number of
pulses indicated.
Insert the programming key, select “SENSORS AND VALVES”, and select “GRND
SPD SENSOR”. The screen to the left will appear.
