Bosch Rexroth BTV 16, Project Planning Manual

Page: 41 / 110

BTV 16/40 Dimensions
5-11
DOK-SUPPL*-BTV16/40***-PR02-EN-P
5.2 Installation
Installation Notes
•
When installing the operator terminal observe to ensure an ergonomic
operation. Additionally, ensure that all moving machine components
are in sight of the operator.
•
Avoid installation locations exposed to direct sunlight, as the screen
readability is reduced and additional heat development can occur.
•
Install the operator terminal in a manner ensuring easy access to the
connector panel (top side).
•
Observe that the LED displays on the front panel are not obstructed.
•
Provide a sufficient minimum clearance of 50 mm for cooling and
cable routing around the device.
•
Lay all connecting cables in loops and use strain reliefs for all cables.
•
Keep a suitably large distance from sources of interference.
Mounting Cut-Out
For mounting the operator terminal proceed as follows:
1. Create a mounting cut-out with 8 holes, diameter 5 mm, according to
the illustrations "Mounting dimensions" on the following page.
2. Insert the operator terminal from the front into the cut-out. Then insert
the mounting bolts M4 into the drilled holes.
3. Fasten the operator terminal by screwing the nuts at the rear side of
the mounting bolts.