Bosch FLYER Mountain, Translation Of The Original Instruction Manual

Page: 178 / 264

176
Status displays
s1 Display
Bicycle lighting/
Charge status display for the Nyon battery
s2 Time indicator
s3 Speed display
s4 North indicator
s5 Display Bluetooth®/WiFi link
s6 Support level indicator
s7 Charge status display for the FLYER battery.
s8 GPS signal indicator
s9 Zoom range/remaining range display
The status displays may vary depending on the
operating mode currently in use.
Set support modes
You can use the operating console (12) to confi -
gure the level of assistance provided by the E-Bi -
ke drive when you are pedalling. The assistance
level can be adjusted at any time, including during
your ride.
Certain versions have a preset assistan -
ce level that cannot be changed. Certain
models may also have fewer assistance
levels to choose from than are shown
here.
If the E-Bike was configured with eMTB
mode ex works, the SPORT assistance
level is replaced by eMTB. In eMTB
mode, the assistance factor and the tor -
que are adjusted dynamically depending
on the pedal force applied to the pedals.
eMTB mode is only available with Per -
formance Line CX drives.
The full range of assistance levels includes:
• OFF : motor assistance is switched off; the E-Bike
is operated like a normal bicycle through pedalling
alone. The pushing aid cannot be activated in this
assistance level.
• ECO : effective assistance with optimum efficiency
for maximum range.
100 m
14:30 22
km/h
s1
s5 s8
s4 s2
s6 s7 s9
s3
105 km
• TOUR : consistent levels of assistance for tours
with large ranges.
SPORT/eMTB
:
• SPORT : powerful assistance for active riding on
hilly terrain and in city traffic.
• eMTB : optimum assistance on any terrain, fast
acceleration, improved dynamics, maximum per -
formance
• TURBO : maximum assistance up to high pedal -
ling frequencies for active riding
Use the «+» button on operating unit 12 to switch
to the next higher support level, and the "-" button
to move down to a lower level. Hold the button
down until you are in the desired support level.
The battery charge status display for your
FLYER battery can be displayed in "Ride" ( r9 )
operating mode or with status display ( s7 ). Each
of the bars in the display corresponds to around
20% of capacity. LED lights up green.
The battery is fully charged.
The battery should be topped up.
There is no longer sufficient energy
available for drive system support and
support will be gradually decreased. The
remaining energy is being used for the
cycle lighting and the on-board com -
puter.
The Nyon has not yet been put in its
holder or it has been reset to its factory
settings.
Nyon has its own battery. The charge status for
this can be seen in display ( s1 ).
Power supply
If your Nyon is in its holder on your FLYER, it is
being supplied with power from the sufficiently
charged battery on your FLYER e-bike. If your
Nyon is not in its holder it draws its power from its
own Nyon battery. Further details of how the Nyon
battery is charged can be read in the enclosed
drive manufacturer's operating manual.
The pushing aid/start-up aid is switched on and
off with the «WALK» button 17 .
The cycle lights can be switched on and off with
button 6 . The lighting symbol ( s1 ) appears when
the lighting is switched on.
If a fault should occur in the E-Bike system com -
ponents, an error code appears in the display.
In addition, please read the original instruction
manual to the Bosch Drive Unit / Nyon enclosed.