Bosch BULLS 650-185, Operating Instructions Manual

Page: 85 / 238

84
Operation
6.5.6 Stem
6.5.6.1 Adjusting the handlebar height with
quick release
Only applies to
ebikes
with this equipment
1 Open the stem clamping lever.
Figure 80: Open (2) and closed (1) stem clamping lever;
All Up used as an example
Figure 81: Pulling the locking lever upwards; All Up used
as an example
2 Pull out the handlebars to the required height.
Observe minimum insertion depth.
3 Close the stem clamping lever.
Adjusting the quick release clamping force
If the handlebar clamping lever stops before
reaching its end position, unscrew the knurled nut .
 Tighten the knurled nut on the seat post if the
seat post clamping lever's clamping force is not
effective enough.

Contact your specialist dealer if the clamping
force cannot be set.
1
2
Crash caused by incorrectly set clamping
force
Applying excessive clamping force damages the
quick release. Insufficient clamping force will
result in unfavourable transmission of force. This
can cause components to break. This will cause a
crash with injuries.
 Never fasten a quick release using a tool (e.g.
hammer or pliers).
CAUTION
!