34
en | Alarm
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
2020-07 | 3.0 | F.01U.378.877
User Guide
Bosch Sicherheitssysteme GmbH
8
Alarm
Notice!
Information on how to handle a fire alarm can be found in
This chapter contains information about the following points:
–
–
–
–
Alarm message to the panel, page 36
Refer to the Fire alarm chapter for the following topics:
–
Acknowledging a message, page 41
–
Silence internal buzzer, page 41
–
Activate and silence signaling devices, page 41
–
Resetting signaling devices and transmission devices, page 41
–
Triggering fire verification, page 42
–
Resetting alarm message, page 43
–
Notice!
Depending on the configuration, the manner in which alarm displays are shown and handled
in this guide may differ from the guide on the system.
8.1
Types of alarm
On the panel controller, a distinction is made between the following types of alarm:
–
Fire
–
Heat
–
Smoke
–
Water
–
Supervisory
Depending on the configuration, external transmission devices (e.g. fire department),
notification appliances (e.g. sirens and/or strobes) and fire protection systems (e.g. sprinkler
systems, fire doors) are activated.
Notice!
If an alarm delay is set for the detector triggering the alarm, the alarm signal is not
transmitted immediately and the message can be checked; see Entry delays.
8.2
Entry delays
To prevent false alarms, it is possible to delay the transmission of the first alarm signal. The
transmission device to the fire department is not activated immediately in this case. During
the delay, the message can be checked to ensure it is correct.
The FSP-5000-RPS programming software can be used to program various strategies for
avoiding false alarms. These strategies are principally used in fire detectors but can also be
assigned to any other detector, depending on how it is configured.
The alarm delays that can be shown in the panel controller display are explained below.
